Take Back the Darknet [Part 2]

Part 2 - Image Raspbian, Basic Settings and Updates

First off we need to get an operating system onto the MicroSD card. We will be using the official image from RaspberryPi.org. At the time of writing the most recent version was Raspbian Jessie Lite (November 2015). To restore this onto a 4GB (or larger) MicroSD we will need one of the following depending on your computer that has this guide open:
Win32 Disk Imager for Windows
ApplePi Baker 1.81 for OS X
– dd for Linux

Once imaging has completed, insert the MicroSD card into the powered off Raspberry Pi then connect it to power and ethernet.

I recommend using a 10 watt (5 volt, 2 amp) power adapter. Using a USB port on your computer probably won’t have enough juice. USB2 comes in a 2.5 watt (5 volt, 0.5 amp) and USB3 hovers around 4.5 watt (5 volt, 0.9 amp). Might cut it, but a dedicated power supply is always going to be a better move, with plenty of amperage left over.

Angry IP Scanner will help you locate your Raspberry Pi on your local network. We are looking for the IP address. Note down it down, we’ll need it to SSH / remotely connect in. Your IP address should be in the format xxx.xxx.xxx.xxx or with either 1, 2 or 3 digits per set of xxx. No, not that type of xxx!

Pickup an SSH client (OS X and Linux already have this built-in):
PuTTY for Windows
Terminal which is built-in to OS X
Terminal which is also built-in to Linux

Login to the Raspberry Pi remotely with the IP address (xxx.xxx.xxx.xxx) you noted down earlier.

ssh pi@xxx.xxx.xxx.xxx

You are now logged in to your Raspberry Pi remotely – congratulations!

Next up we need to run basic setup options so at the command line type

sudo raspi-config

From this menu we want to do the following.
– Expand Filesystem – This will fill the MicroSD card.
– Overclock – Set to None – No need for this.
– Advanced, Hostname – Change to WebServer – So we know what it is.
– Advanced, Memory Split – Set to 16MB (lowest), 0 doesn’t work.
After completing these it will ask to reboot, reboot and you will be logged out of your terminal / PuTTY session.

Once rebooted (~30 seconds), Log back in with SSH to your server.

ssh pi@xxx.xxx.xxx.xxx

This is an important command to remember for software updates. If you know nothing else, remember this line.

sudo apt-get update && sudo apt-get upgrade

Once all updates have installed, reboot for good measure.

sudo reboot

Advance onward to part 3 or head back to the table of contents on page 1.

Leave a Reply